Sometimes, the water inlet valve works perfectly fine, but the problem is with the timer. That could lead to some water flowing into the tub but not up to the required levels to begin the wash cycle. Why it fails: When the water inlet valve is faulty, it could fail to open entirely and let enough water in. Once you’ve chosen the wash cycle that you want to use for your load of laundry, the timer will take over and ensure that each process happens as it should.
It coordinates all of the different functions in a washer from filling to spinning and draining. On the other hand, the timer is often seen as the ‘brain’ of the washer.
It opens to let water in but closes as soon as the tub is full so that it doesn’t overflow.
What it is: The water inlet valve on a washer is what controls the amount of water that fills up the washer tub. There are two possible causes for this, being a fault in the water inlet valve or the timer. Remember: you’ll need to disconnect the power supply before you gain access to replace the belt. Once you’ve done that, turn the washer manually to ensure that the belt is well-aligned on both pulleys. Then, with a bit of force, you’ll need to loop the other end of the belt around the motor pulley as well. Loop one end of the belt around the drum pulley. That’s because a brand new belt will be taut compared to the old one. When you can see the belt’s location clearly, you’ll find that removing the old belt is much simpler than installing the new one.
On a top-load washer, the belt will be on the bottom end of the unit, requiring you to gain access by removing the panel and any other parts in the way.īe sure to refer to your particular unit’s user manual for any special instructions on gaining access. So, let’s break it down into two stages: gain access and replace the belt.
How to fix: Worn-out drive belts need to be replaced, which can be quite a tricky process. Without enough tension in the belt, very little water can be spun out of that load and drained out of the tub. This problem becomes most noticeable when you put in a heavy load of laundry into the machine. As a result, the washer won’t be able to drain all of the water out of the load of laundry that you’ve put in there.Ĭlick here to use the chatbox to speak with one of our technicians. Without sufficient tension, the belt can’t spin the washer fast enough. Over time, though, the belt will start to wear out and lose all of the tension needed to do its job. Why it fails: For the belt to work correctly, it’ll require a lot of tension so it can spin the washer with enough power. That will continue happening back and forth until the entire washing process is complete. The drive motor will deliver power by turning the belt, passing it on by turning the washer’s tub. Whether it’s agitating the stains out from your clothes or spinning the clothes dry, the drive belt is there every step of the way. The belt works closely with pulleys and the drive motor to spin the washer fast enough to do its job effectively. What it is: Among all the parts in a Speed Queen washing machine, the drive belt is undoubtedly one of the most important. Typically, the root cause behind this issue is a problematic drive belt. We’re talking about the question of why the washer is not draining as it should.